7/31/2023 0 Comments Ansys apdl view command history![]() ![]() There is contamination in the slide guides. The incoming air flow or pressure is incorrect. Tool change was interrupted before completion.Ī tool change was attempted before adequate air pressure was present.Ī tool change was attempted with the pocket already down.Ĭarousel rotation was prevented by an obstruction. ![]() ![]() VMC, HMC - Side-Mount Tool Changer - Manual Recovery No power to the carousel motor or the carousel motor is damaged.Ĭheck that the carousel can be rotated in the manual recovery mode. Rotate the carousel in recovery mode and test the sensors and cabling. The carousel tool in position, tool one in position, pocket up or down proximity sensor is damaged or contaminated. Replace the idle sprocket and bushing, see 100 PKT SMTC sprocket replacement section. Drive sprocket moved out of the motor shaft due to failed bushing causing the idle sprocket to fail. 100 PKT SMTC Carousel stopping in between pockets unable to recover. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |